Goldstar, Sears, and Zenith VCR replacement rubber kits. The on-line database has been set up to direct you to the proper rubber replacement or Maintenance kit for your VCR.  Even though every precaution has been taken to assure the accuracy of the database, mistakes can be made.  If you have doubts about the pictured VCR being similar to yours please check the chassis photos below.  If you feel that we've made a mistake, please E-Mail us   and let us know. We have three replacement rubber kits for these VCRs, manufactured by Goldstar. MBK-53: Belt Kit Contains the only belt that is used in these VCRs that were built by Goldstar.   Your price for our MBK-53 kit is $1.25.   MBK-53P: Complete Rubber Kit This kit is a complete rubber replacement kit for these Goldstar VCRs.   It contains the belt and pinch roller.   If the pinch roller has never been replaced you probably need one.   If the pinch roller has a hard glaze on it or the capstan shaft has a black build up on it the pinch roller has probably been slipping.   Your price for our MBK-53PT kit is   $7.75.   MBK-53-LED: Infra-Red LED The Infra-red LED that was used in these VCRs is a bit weak and will cause the VCR to detect a cassette when there is not one present.   The most common symptom of a weak or defective LED is the VCR will try to load a cassette as soon as it is powered up.   Normally it will attempt the load several times then shut down.   The VCR may also accept a cassette then immediately eject it.   Your price for our MBK-53-LED is $3.00.   Soldering required.   Top view of Goldstar Chassis Our MBK-53 Series of parts are for this chassis Bottom view of Goldstar Chassis Our MBK-53 Series of parts are for this chassis