Hitachi, Burle, GE, JC Penney, Scott, Pentax, RCA, and Sears VCR replacement rubber kits.
Your VCR may have the GE, JC Penney, Scott, Pentax, RCA, or Sears name on it instead of Hitachi.   Your VCR is probably a front loading unit, instead of the top loader, pictured.   The VCRs covered by our MBK-14 series of parts kits were built about the time that manufactures were just starting to build front loading VCRs.   These VCRs are some old work horses and we try to stock enough parts so that you can keep them working properly. The on-line database has been set up to direct you to the proper rubber replacement kit for your VCR.  Even though every precaution has been taken to assure the accuracy of the database, mistakes can be made.  If you have doubts about the pictured VCR being similar to yours please check the chassis photos below.  If you feel that we've made a mistake, please E-Mail us   and let us know.


We have three replacement rubber kits for these VCRs, manufactured by Hitachi.



MBK-14
Contains all six belts, Capstan belt, idler belt, counter belt, and both load belts.   The load belts in these VCRs are probably the most common source of problems.   As they get old and deteriorate they will begin to slip and the VCR will not fully load.   The most common symptom being that you will hear the VCR attempt to power up but it will shut down before completing the power up sequence.   Your price is $17.95.

Instructions for installation (PDF)


See photo for belts placement


MBK-14-LB
Load Belt Kit
Contains the two load belts that are used in these VCRs.   The two small load belts are the first belts which usually fail.  The most common symptom of  bad load belts is the VCR will be unable to go into the play or record mode - it will load the tape around the video drum, but will shut down before the tape starts to move.   You may also hear a squealing sound at this point as the belts start slipping.  
See photo for belt locations.


Your price for our MBK-14-LB kit is $6.50.

Instructions for installation (PDF)


See photos for belt locations.




MBK-14-I
Replacement Idler Assembly.  Sometimes the tire is the only part of the idler assembly that needs to be replace.  Occasionally the idler assembly will lose tension and cause the idler to fail to engage the reels.  Your price is $3.95


See photo for idler placement





Top view of Hitachi Chassis
Our MBK-14 series of parts are for this chassis



Bottom view of Hitachi Chassis
Our MBK-14 series of parts are for this chassis